DIY PPF Kits | Dura-Seal Ultra Ceramic Coating

Real Carbon Look & Matte Finish

DIY PPF Film Kits

For a truely unique and sharp finish, real carbon, gloss carbon and matte finish PPF film adds the extra distinction.

Update your vehicles look with computer cut real carbon look PPF film.

Protect your vehicle with our range of multi layer films from Clif Designs and OptiCoat. Our films provide tailored solutions to meet the needs of every vehicle and owner. With built-in UV protection, you can enjoy long-lasting PPF stone chip protection without worrying about discoloration. From everyday use protection for door edges and handles to advanced options for high-mileage travelers, we have you covered. Trust Dura-Seal Ultra Ceramic Coating for reliable and durable protection.



Mirrors



Grill Surround, Rocker Cover Sills



Rear Spoiler



Full Bonnet & Roof



B & C Pillars



PPF Full And Partial Vehicle Options

Have A Question

Find A Pattern For Your Car

Name

Email Address

Phone

Vehicle Make

Vehicle Model

Vehicle Year

I Am Interested In PPF For I Am Interested In PPF For Mirrors B & C Pillars* Lower Rocker Cover Sills Rear Spoiler or Top Hatch Spoiler Front Grill Surround Front Air Dam Full Roof Full Bonnet Other

Message

Full right side shot with stairs reflecting in paint surface after coating

Automotive

Protect your vehicles paintwork from unsightly scuffs, stone chips, pin-striping and the ravages of pollution damage.

Computer Cut PP
Custom Fit PPF
Personalised PPF Options

Looking toward roof after ceramic coating applied

Motorhome & Caravan

Protect your motorhome and caravans high-wear areas from scuffing and stone chips with PPF film. Get added protection and ease of cleaning with Dura-Seal Ultra over the top of the PPF.

Custom Fit PPF For RV’s
Personalised PPF Options
Can Be Ceramic Coated With Ultra

Full front and right side after coating applied

Marine

For the best PPF surface protection that can have a ceramic coating applied over the top. Our PPF films for marine and jetski use provide multiple protection options.

Custom Fit PPF For Marine
Hard Wearing Surface
Can Be Ceramic Coated With Ultra

Application Process



Step 1: Surface Preparation

Apply a deep clean solution to lift and pollutants from the paintwork and ensure no dirt can get under the PPF film during application. Water blasting any crevices adjacent to the area where your PPF is to be applied.



Step 2: Remove and Mist

Making sure your hands are clean, and wet with the slip solution. Mist the top of the film with slip solution before removing it from the backing. Then mist the back of the film.

We computer cut or custom fit to the vehicle surface. While many computer patterns exist for a wide range of makes and models. Many may require a custom fit PPF application for the best surface match.



Step 3: Application

Align the film within the designated area before application. If the film moves too easily, gently lift and mist the vehicle surface with the ISO mix. Once aligned, spritz Slip-Solution on the top of the film and firmly run the squeegee from the center to the edges, ensuring the film stays moist. Push out any air pockets and water underneath the film. Keep the top of the film consistently wet with slip solution throughout the process.